Filter
Top Products
INSTALLATION MANUAL ON CISS FOR PRINTER CANON IX 4000/IP 4200
5
IV. Chips recorder disappears
When printer works for some time, it will notice you that the cart ridge is out of
ink, and can't goon printing, choose "confirm "or "yes "butt on, press "Recover "butt
on for about 10 seconds then you can go on printing. After this step, the computer can't
show the real cartridge ink volume, the indicator shows empty. You do need redo this
step for many times till all ink volume shows empty.
Remark: The printer can't show the real cartridge ink volume and computer
show it as empty, this is normal case, you just need to guarantee that there is ink in the
cartridge, you can go on printing as normal.
IV. Take the CISS off
During printing, if you need to take the system off, please first take off air filter,
insert back air plug, move tube valve to CLOSE position (4-1-1), Move out cartridge
holder, detach the rack (4-1-2) (can't be too rude to change the shape of rack). Take ink
cartridges out, press back the red cover at 45 degree angle (4-1-3).
Notice: If you do not close the tube valve before taking the cartridge out, or you
do not install the red cover back to cartridge, it maybe result that ink in the cartridges
will flow back to the external tank or flow out from the cartridge nozzle, these case will
damage the second normal use of system.
Pic. 4-1-1 Pic. 4-1-2 Pic. 4-1-3
V. Refill ink
During printing, if you found out that the ink level in the tank is below the red
line, please add ink according to the methods.
VI. Check air balance tube
During printing, if you find some abnormal cases, such as bad output, ink drip
out on paper, then you need to check the air balance tube to see if exist ink. If yes,
please do according to the manual of "ink pump out from balance tube”.
VII. Warnings
1. During printing, please do not take cartridges over than the printer. Please
keep ink tank and printer in the same level.
2
.
During printing, do not inverse, lift up or lower ink tanks.