Filter
Top Products
42
6.2.2 General
• Be aware of abnormal conditions.
If the IT-10 is continuously used in an abnormal condition, a fire or electric shock may occur. If there is an
abnormality, immediately turn off the Power switch, and be sure to remove the batteries and then contact a
CASIO distributor for repair.
• Supply Current/Voltage
• Do not use an AC adaptor with AC voltage not rated on the AC adaptor. Also, avoid drawing power from
Do not damage, break, retrofit, bend, twist, or stretch the power cable. Also, do not place a heavy object on it
or heat it. If this is done, the power cable may be broken and cause a fire or electric shock.
• AC adaptor
Always use the dedicated AC adaptor (AD-S15050AE). If an AC adaptor that is not specified is used, the
battery pack may explode, causing a fire or personal injury.
• Do not touch the AC adaptor with wet hands.
This may result in an electric shock. Also, place the AC adaptor in a place where it is not subject to dust and
water. Dust and dirt may cause fire and smoke, and water may cause an electric shock.
• About the electrolyte
If the internal electrolyte of the battery leaks and enters the eye, rinse it with a sufficient amount of water, then
consult with a doctor
• About the battery pack
1. Do not place the battery pack in a microwave oven or high-pressure container. If this is done, the
battery pack will be quickly heated or the contact seal may be broken causing it to become hot, smoke,
explode, or ignite.
2. If you are aware of an abnormal condition such as a smell, excessive heat, discoloration, deformation,
etc., during use, charging and storage of the battery pack, immediately remove it from the IT-10 and do
not use it anymore. If it continuously used without proper treatment, the battery pack may become hot,
smoke, explode, or ignite.
3. If charging cannot be completed even after the specified charging period, stop the charge operation.
Otherwise, the battery pack may become hot, smoke, explode, or ignite.
4. If the battery pack leaks or generates an abnormal smell, immediately remove it away from the fire.
Otherwise, the electrolyte that has leaked may ignite causing smoke, an explosion, or fire.
5. Do not disassemble the battery pack. Neither disassemble nor retrofit this terminal. Personal burns or
injury may occur.
• About the power cable and AC adaptor
1. Do not bring the power cable close to heating equipment such as stove. The cable coating may burn or
melt, resulting in fire or electric shock.
2. Do not bring the power cable close to a container filled with liquid. If the cable becomes wet or should
the container be tipped over, a fire or electric shock may result.
3. Do not unplug the AC adaptor by pulling the power cable by hand. The cable may be damaged causing
a fire or electric shock. Always hold the plug of the cable.
4. When cradle or battery charger is not used for an extended period of time, e.g. during absences, unplug
the AC adaptor from the wall outlet.