Filter
Top Products
E-6
Deg Rad Gra Specifies degrees, radians or grads as the angle
unit for value input and calculation result display.
Note: In this manual, the B symbol next to a sample operation indicates
degrees, while the * symbol indicates radians.
Fix Sci Norm Specifies the number of digits for display of a
calculation result.
Fix: The value you specify (from 0 to 9) controls the number of decimal
places for displayed calculation results. Calculation results are rounded off
to the specified digit before being displayed.
Example: 1 100 ÷ 7 = 14.286 (Fix 3)
14.29 (Fix 2)
Sci: The value you specify (from 1 to 10) controls the number of significant
digits for displayed calculation results. Calculation results are rounded off to
the specified digit before being displayed.
Example: 1 1 ÷ 7 = 1.4286 s 10
–1
(Sci 5)
1.429 s 10
–1
(Sci 4)
Norm: Selecting one of the two available settings (Norm 1, Norm 2)
determines the range in which results will be displayed in non-exponential
format. Outside the specified range, results are displayed using exponential
format.
Norm 1: 10
–2
|x|, |x| > 10
10
Norm 2: 10
–9
|x|, |x| > 10
10
Example: 1 1 ÷ 200 = 5 s 10
–3
(Norm 1)
0.005 (Norm 2)
Aab/c A d/c Specifies either mixed fraction (ab/c) or improper
fraction (d/c) for display of fractions in calculation results.
fx-95ES PLUS: ACMPLX a+b
i ; rθ Specifies either
rectangular coordinates (
a+bi) or polar coordinates (rθ) for EQN Mode
solutions.
fx-82/85/350ES PLUS: ASTAT ON ; OFF
fx-95ES PLUS: ASTAT ON ; OFF
Specifies whether or not to display a FREQ (frequency) column in the STAT
Mode Stat Editor.
fx-82/85/350ES PLUS: ADisp Dot ; Comma
fx-95ES PLUS: ADisp Dot ; Comma
Specifies whether to display a dot or a comma for the calculation result
decimal point. A dot is always displayed during input.
Note: When dot is selected as the decimal point, the separator for multiple
results is a comma (,). When comma is selected, the separator is a
semicolon (;).
fx-82/85/350ES PLUS: A;CONT
fx-95ES PLUS: A;CONT
Adjusts display contrast. See “Adjusting Display Contrast” for details.
Initializing Calculator Settings
Perform the following procedure to initialize the calculator, which returns the
calculation mode to COMP and returns all other settings, including setup
menu settings, to their initial defaults.
(CLR)(Setup)(Yes)