Filter
Top Products
E-9
Specifying the Fraction Display Format
To specify this fraction
Perform this key operation:
display format:
Mixed 1Nc1(ab/c)
Improper 1Nc2(d/c)
Specifying the Statistical Display Format
Use the following procedure to turn display of the frequency (FREQ)
column of the STAT Mode STAT editor screen on or off.
To specify this: Perform this key operation:
Show FREQ Column 1Nc3(STAT)1(ON)
Hide FREQ Column 1Nc3(STAT)2(OFF)
Specifying the Decimal Point Display Format
To specify this decimal
Perform this key operation:
point display format:
Dot (.) 1Nc4(Disp)1(Dot)
Comma (,) 1Nc4(Disp)2(Comma)
• The setting you configure here is applied for calculation results
only. The decimal point for input values is always a dot (.).
k Initializing the Calculation Mode and Other
Settings
Performing the following procedure initializes the calculation mode
and other setup settings as shown below.
19(CLR)1(Setup)=(Yes)
This setting: Is initialized to this:
Calculation Mode COMP
Input/Output Format MthIO
Angle Unit Deg
Display Digits Norm1
Fraction Display Format d/c
Statistical Display OFF
Decimal Point Dot
•To cancel initialization without doing anything, press A(Cancel)
instead of =.