Casio IT-9000 Barcode Reader User Manual


 
E-39
Handling SIM/SAM Cards
The Handheld Printer Terminal supports SIM cards and SAM cards. (The IT-9000-
E/05E/05E-CN/20E/25E/IT-9000E-C25E/MC25E models only support SAM cards.)
Since the SIM/SAM card slot is located inside the battery pack compartment, rst
remove the battery pack when installing or removing a SIM/SAM card.
Refer to pages 23 to 25 for information on “Loading and Removing the Battery Pack”.
Install (or remove) a SIM/SAM card according to the procedure described below.
The type and number of cards varies depending on model.
Installing
1. Make sure that the power on the terminal has been switched off. If the power is still
on, press the power key to switch off the power.
2. Remove the battery pack.
3. Using the tip of a screwdriver or similar tool, lift up the tab on the slot cover and
remove the slot cover as shown in the illustration.
4. Slide the SIM/SAM card cover in the "Unlock" direction and lift up the end of the
cover to open it.
5. Insert the SIM/SAM card.