Filter
Top Products
E-14
2. Press L twice to change to the text delete
prompt.
3. Press SET.
• If all of the text does not fit on the display, you
can use H and J to scroll it to the left and right.
4. Use K and L to select Area 1 or Area 2 then
press SET.
5. Press SET to delete the text from the area that is currently on the display.
Part 8 Reference
This section contains information about the Label Printer that you can use as
reference when you need it.
Replacing the Tape Cutter Blade
The tape cutter blade is designed to provide approximately 3,000 cuts. Use the
following procedure to replace the blade whenever it starts to cut poorly.
To replace the tape cutter blade
1. Make sure that the Label Printer is switched off.
2. Open the tape cartridge compartment cover.
1. While the input screen is on the display, press
FUNCTION and then 1 (MEMO).
• Note that text recalled from memory will replace
any text currently on the display.
2. Press L to change to the text recall prompt.
3. Press SET.
• If all of the text does not fit on the display, you
can use H and J to scroll it to the left and right.
4. Press L to change to Area 2.
• Use K and L to switch between Area 1 and
Area 2.
5. Press SET to recall the text from the area that
is currently on the display.
• Note that recalling data from memory replaces
anything that is currently on the input display.
Memory text cannot be appended.
To delete text from memory
1. While the input screen is on the display, press
FUNCTION and then 1 (MEMO).
CAL?
ABCD
CASI
Area 2 text
Area 1 text
CASI
STR?
STR?
ABCD
Area 1 text
OK?
DEL?