Filter
Top Products
3. SETUP
Lamp
You will need to install a lamp prior to the initial operation of the fixture. A 250W lamp is included.
Warning! When replacing the lamp, please wait 15 minutes after powering down to allow the
unit to cool down! Always disconnect from main power prior to lamp replacement.
Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp
with alcohol and wipe it with a lint free cloth before installation.
Lamp Installation
Figure A
Figure B
1) Open the top cover by removing the s
screws indicated in Figure A.
ix
loth.
2) Lift the lamp and socket vertically away
from the fixture.
3) Remove the lamp from the socket.
4) Hold the new lamp with a lint-free c
Insert the lamp into the socket.
5) Reinsert the lamp into the fixture.
6) Replace the top cover.
SX Mix Manual 6
2006-12-11/15:22