Filter
Top Products
Fuse Replacement
Disconnect the power cord before replacing a fuse and always
replace with the same type fuse.
The fuse is located
inside this
compartment.
Remove using a flat
head screwdriver.
FUSE
With a flat-head screwdriver, unscrew the fuse
holder from its housing. Remove the damaged
fuse from its holder and replace with exact
same type fuse. Insert the fuse holder back in
its place and reconnect power.
Mounting
ORIENTATION
This fixture may be mounted in any position provided there is adequate room for ventilation.
RIGGING
Hanging Clamp
It is important never to obstruct the fan or vents pathway. Mount the
fixture using, a suitable “C” or “O” type clamp. Adjust the angle of the
fixture by loosening both knobs and tilting the fixture. After finding the
desired position, retighten both knobs.
x When selecting installation location, take into consideration lamp
replacement access and routine maintenance.
x Safety cables should always be used.
Note!
Clam
x Never mount in places where the fixture will be exposed to rain, high
humidity, extreme temperature changes or restricted ventilation.
p
is sold se
p
aratel
y
.
4. OPERATING INSTRUCTIONS
1) Use the moonflower mode switch to set the mode of rotation (up = continuous rotation mode,
down = sound-active mode).
2) Use the gobo mode switch to set the mode of rotation (up = continuous rotation mode, down =
sound-active mode).
3) Turn the focusing lens to focus the beam onto your projection surface.
SX Mix Manual 7
2006-12-11/15:22