Filter
Top Products
Operating Instructions
DMX-55 User Manual 17 2006-01-11 11:59:07
Midi Operation
The controller will only respond to MIDI commands on the MIDI channel which it is set to full stop. All
MIDI control is performed using Note on commands. All other MIDI instructions are ignored. To stop a
chase, send the blackout on note.
Action
1) Press and hold the MIDI/REC button for
about 3 seconds.
2) Select the MIDI control channel (1~16)
via the BANK UP/DOWN
buttons to set.
3) Press and hold the MIDI/REC button for
3 seconds to save settings.
4) To release MIDI control, press any other
button except the BANK buttons during
step 2.
Notes
This is the Channel that the controller will receive
MIDI note commands.
MIDI NOTE FUNCTION (TURN ON/OFF)
00 to 07
Scenes 1~8 in BANK 1
08 to 15
Scenes 1~8 in BANK 2
16 to 23
Scenes 1~8 in BANK 3
24 to 31
Scenes 1~8 in BANK 4
32 to 39
Scenes 1~8 in BANK 5
40 to 47
Scenes 1~8 in BANK 6
48 to 55
Scenes 1~8 in BANK 7
56 to 63
Scenes 1~8 in BANK 8
64 to 71
Scenes 1~8 in BANK 9
72 to 79
Scenes 1~8 in BANK 10
80 to 87
Scenes 1~8 in BANK 11
88 to 95
Scenes 1~8 in BANK 12
96 to 103
Scenes 1~8 in BANK 13
104 to 111
Scenes 1~8 in BANK 14
112 to 119
Scenes 1~8 in BANK 15
120
Chase 1
121
Chase 2
122
Chase 3
123
Chase 4
124
Chase 5
125
Chase 6
126
BLACKOUT
Data Transfer
It is possible to transfer the programs stored in one DMX-55 controller to another. Connect from the
DMX output of the programmed controller to the DMX input of the other.
Action
1) Source unit: Turn unit Off, press and
hold SCANNER buttons 2, 3 and
SCENE button 1 then turn unit back On.
2) Destination unit: Turn unit Off, press
and hold SCANNER buttons 8, 9 and
SCENE button 2 then turn unit back On.
3) Both units are now ready to transmit
and receive. Press SCENE buttons 7 &
8 simultaneously on Source unit to
begin transmission.
Notes
The display should show TRANSMIT, this indicates it
is ready to transmit data.
The display should show RECEIVE, this indicates it is
ready to receive data transmission.