Filter
Top Products
Stacking Frame Installation Instructions
013-100342-01 (Rev.1) (08/06) 6 of 12 pages
Hoisting Procedure
Warnings
Remove the projector lens before hoisting.
The frame is designed to support a maximum stacking capacity of three
projectors. Always stack before hoisting.
All rigging must be in compliance with applicable local safety codes.
Only licensed riggers should perform the following procedures.
Use metric hardware only. Never force incompatible threads.
Never hoist a projector by its feet or any other component.
The projectors can be stacked and hoisted in either an upright or inverted
position. Do not mix orientations in a stack (i.e. inverted and upright).
Use this procedure to hoist one projector or a stack of projectors. To hoist a stack, first
mount two or three projectors according to the stacking procedure included in these
instructions. There are two hoisting techniques available. These two options are used for
the various stacking combinations and for the hardware options available. These options
include, hoisting via the stacking frame handles or hoisting via the hardware on
Roadster/Mirage S+ and Roadster HD12K models.
Key Points:
• When hoisting a stack combining Roadster/Mirage S+ and Roadster HD12K
models with any of the models listed in Table 1, use the hardware provided with
the Roadster/Mirage S+ and Roadster HD12K models to hoist the stack.
• When hoisting via the stacking frame handles leave a 150mm space between the
rigging hardware.
• Connect safety cables and rigging equipment to the designated locations on the
stacking frame.
• Use the two eyebolts on the stacking frame as safety points.
• Use hoisting and rigging equipment suitable to the application; such as clamps,
cables, eyebolts, or straps that accommodate the load rating. All integral, metric
hardware on the rigging hardware accepts an M12 thread only.
OFFICIALLY RELEASED
Document Control
September 8, 2006