Filter
Top Products
53
Setting
Analog out
The ANALOG OUT terminal is for output of the analog signal
coming from the ANALOG IN terminal in the Input 1 terminals.
(See page 12.)
Select “On” to enable the signal output through the ANALOG
OUT terminal always except in the stand-by mode or “Off” to
disable the signal output.
Analog out is not available when selecting the other Inputs except
Input 1. Select Input 1 so that Analog out will be available. (p30,
36)
Lens memory
Lens memory feature enables you to store the lens shift, zoom
and focus adjustment for each Input. When selecting Lens
memory, Input 1~5 will be displayed. Move the pointer to an Input
and press the SELECT button. Choose one of the following
settings for the Input.
Off . . . . . . . . applies the lens shift, zoom and focus adjusted
last.
Memory . . . . stores the lens shift, zoom and focus currently
adjusted for each input. When switching to the
input with “Memory” selected, the lens moves
to the stored position.
Lens memory
Shutter function is available to block out light to the screen, so that
the screen can be used for the other presenters. In addition, this
function enhances the effectiveness of contrast by 80% opening
up the shutter inside the projector.
Each setting for the Shutter function can be altered as follows:
Level
Sets up shutter level when closing the mechanical shutter.
Normal . . . . . . . . . .0% light blocking
High contrast . . . . .20% light blocking
Protection
Prohibits the shutter operation from the remote control and the
projecto’s top control.
Remote control . . Selecting “On” prohibits the shutter
operation from the remote control.
Projector . . . . . . Selecting “On” prohibits the shutter
operation from the top control.
It is possible to prohibit the shutter operation from both of the
remote control and the top control.
Shutter
Shutter level
Shutter protection
Setting
Select [Yes]
to activate the
setting.
Press the SELECT button at
Lens memory and choose an
Input for which you want to
store the lens shift, zoom and
focus adjustment and then
select “Memory” for the input.
When pressing the SELECT button at Shutter, the
Shutter setting menu appears. Select Protection and
then a desired setting for Remote control and Projector.
✔Note:
• Lens memory is available only in the lens having memory functions of itself. Contact
to the sales dealer or the service station for available lens.
• 100% accurate lens memory is not guranteed. If an accurate lens position, zoom
and focus cannot be obtained with Lens memory function, adjust them respectively
in each case.