Filter
Top Products
3-18
Cisco IOS Dial Services Quick Configuration Guide
Chapter 3 Configuring the Cisco 1604 Router
Step 6—Testing the Cisco 1604 Connection to the Cisco AS5300
k. See 08:03:55.
The robo-austin PPP peer is successfully authenticated by the hq-sanjose peer.
(
BR0:1 CHAP: I SUCCESS id 5 len 4)
l. See 08:03:55.
MultiLink PPP uses a virtual-access interface to host the bundle.
(
BR0:1 PPP: Phase is VIRTUALIZED)
m. See 08:03:56.
LCP on Virtual-Access2 is forced up as it was already negotiated on the physical interface. For
more information, enter the show interface virtual-access2 conf and debug vtemp commands.
(
%LINK-3-UPDOWN: Interface Virtual-Access2, changed state to up)
(
Vi2 PPP: Phase is UP)
n. See 08:03:56.
IPCP negotiation begins.
(
Vi2 IPCP: O CONFREQ [Closed] id 1 len 10)
(
Vi2 IPCP: Address 10.1.254.4 (0x03060A01FE04))
o. See 08:03:56.
IP can now be used across this PPP connection.
(
Vi2 IPCP: I CONFACK [ACKsent] id 1 len 10)
(
Vi2 IPCP: State is Open)
p. See 08:03:57.
A route is installed to 10.1.254.1 to match the IP address negotiated by the peer.
(
BR0 IPCP: Install route to 10.1.254.1)
q. See 08:03:57 and 08:04:01.
The connection is made to hq-sanjose.
(
Line protocol on Interface Virtual-Access2, changed state to up)
(
Interface BRI0:1 is now connected to 14085551234 hq-sanjose)
robo-austin# ping 10.1.254.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.1.254.1, timeout is 2 seconds:
.!!!!
Success rate is 80 percent (4/5), round-trip min/avg/max = 116/182/372ms
robo-austin#
08:03:55: BRI0: Dialing cause ip (s=10.1.254.4, d=10.1.254.1)
08:03:55: BRI0: Attempting to dial 14085551234
08:03:55: ISDN BR0: TX -> SETUP pd = 8 callref = 0x2F
08:03:55: Bearer Capability i = 0x8890
08:03:55: Channel ID i = 0x83
08:03:55: Keypad Facility i = '14085551234'
08:03:55: ISDN BR0: RX <- CALL_PROC pd = 8 callref = 0xAF
08:03:55: Channel ID i = 0x89
08:03:55: ISDN BR0: RX <- CONNECT pd = 8 callref = 0xAF
08:03:55: ISDN BR0: TX -> CONNECT_ACK pd = 8 callref = 0x2F
08:03:55: %LINK-3-UPDOWN: Interface BRI0:1, changed state to up
08:03:55: BR0:1 PPP: Treating connection as a callout
08:03:55: BR0:1 PPP: Phase is ESTABLISHING, Active Open
08:03:55: BR0:1 PPP: No remote authentication for call-out
08:03:55: BR0:1 LCP: O CONFREQ [Closed] id 42 len 28
08:03:55: BR0:1 LCP: MagicNumber 0x623E5C69 (0x0506623E5C69)
08:03:55: BR0:1 LCP: MRRU 1524 (0x110405F4)
08:03:55: BR0:1 LCP: EndpointDisc 1 Local
(0x130E01726F626F2D61757374696E)
08:03:55: BR0:1 LCP: I CONFREQ [REQsent] id 7 len 32
08:03:55: BR0:1 LCP: AuthProto CHAP (0x0305C22305)
08:03:55: BR0:1 LCP: MagicNumber 0xE16A73E6 (0x0506E16A73E6)