Filter
Top Products
9-4 LightStream 1010 ATM Switch PAM Installation Guide
Connecting the Interface Cables and Checking the LEDs
Figure 9-2 25-Mbps PAM Applications
Connecting the Interface Cables and Checking the LEDs
All ATM interfaces are full duplex. You must use the appropriate ATM interface cable to
connect the ATM UTP PAM interface with an external ATM network.
This section describes the following:
• ATM Connectors
• 25-Mbps PAM Network Connections and LEDs
ATM Connectors
The 96-pin Molex connector is used to connect the 12 RJ-45 UTP to the end workstations.
See the section “Preparing Network Connections” in the chapter “Preparing for
Installation” for a description of a 96-pin Molex connector.
For UTP traffic, use the RJ-45 connector to connect the 25 Mbps PAM to the workstations.
See the section “Preparing Network Connections” in the chapter “Preparing for
Installation” for a description of an RJ-45 connector.
NM3992
ATM switch
25-Mbps
connections
25-Mbps
connections
Distribution
block