Filter
Top Products
6 Installing the Cisco RPS Adapter Plate in Cisco 2600 Series Routers
Removing the Cover
Take these steps to remove the chassis cover:
Step 1 Power OFF the router.
Step 2 Attach an ESD-preventive wrist strap.
Step 3 Disconnect all cables from the rear panel of the router.
Step 4 Place the router so that the front panel is facing you. Remove the screws located on top
of the cover near the front edge.
Step 5 Slide the cover away from you until the metal tabs on the side edges separate from the
chassis bottom, as shown in Figure 2.
Figure 2 Removing the Cover
Step 6
Lift the front edge of the cover until it clears the front of the chassis, as shown in Figure 3.
Figure 3 Lifting the Cover
Step 7 Lift the cover until it is free from the chassis and then set it aside.
Warning Before opening the chassis, disconnect the telephone-network cables to avoid
contact with telephone-network voltages.
Warning Do not work on the system or connect or disconnect cables during periods of
lightning activity.
POWER RPS ACTIVITY
H11658
Cisco 2600
SERIES
H11659
POWER RPS ACTIVITY
Cisco 2600
SERIES