Filter
Top Products
26
Install Field Replaceable Units (FRUs)
Prepare to Remove and Install
an RSP
To remove and install an RSP, you will perform the
following steps:
• Copy the configuration file using a Trivial File
Transfer Protocol (TFTP) server
• Remove the RSP
• Install the RSP
• Connect to the RSP
• Turn the system power back on, if it has been
turned off
• Retrieve the configuration file
• Configure high systemavailability (HSA) or high
availability (HA) features, provided you are
using two RSPs (Follow the instructions in the
appropriate Route Switch Processor Installation
and Configuration Guide, such as the Route
Switch Processor 8 (RSP8) Installation and
Configuration Guide.)
Note The high system availability (HSA) and high
availability (HA) features are beyond the scope of
this Quick Start Guide. For information on
configuring your router for HSA or for HA, refer to
the appropriate Route Switch Processor Installation
and Configuration Guide, such as the Route Switch
Processor 8 (RSP8) Installation and Configuration
Guide.