Filter
Top Products
3-14
Cisco AS5800 Universal Access Server Dial Shelf Card Guide
78-7097-03
Chapter 3 Channelized T3 Trunk Card
Configuring the CT3 Trunk Card
To verify your software configuration, you can enter show commands to display clock (show dial-shelf
clock) and controller (show controller t3) settings. To enter show commands, you must be in
privileged EXEC mode. Some examples:
AS5800# show dial-shelf clock
Primary Clock:
--------------
Slot 12:
System primary is 1/1/0:2 of priority 213
TDM Bus Master Clock Generator State = NORMAL
Backup clocks:
Source Slot Port DS3-Port Priority Status State
-------------------------------------------------------------
Trunk 0 1 0 206 Bad Default
Trunk 0 2 0 212 Bad Default
Trunk 1 4 0 225 Good Default
Status of trunk clocks:
-----------------------
Ds3 2 2 2 2 2 2 2 2 2 1 1 1 1 1 1 1 1 1 1
Slot Port Type 8 7 6 5 4 3 2 1 0 9 8 7 6 5 4 3 2 1 0 9 8 7 6 5 4 3 2 1
0 0 T3 G G G G G G G G G G G G G G G G G G G G G G G G G G G G
1 0 T3 B B B B B B B B B B B B B B B B B B B B G G G G G G G G
Step 13
AS5800(config)# dial-tdm-clock priority
{
1
-
50
} {
external
|
trunk-slot
} {
0
-
5
}
ds3-port 0 port {
1
-
28
}
Configure clock priority, which is a value from 1 to 50.
Select a clocking source by selecting an external
reference clock or a trunk card. If you are using an
external reference clock, no other CLI is needed. If you
are using a trunk card, select a dial shelf slot from
0 to 5.
Select the T3 port number, which has a value of 0.
Step 14
AS5800# copy running-config
startup-config
Save your changes when ready.
1. To deactivate a command functionality, type no before the command.
Table 3-3 T3 Configuration Commands (continued)
Command Description