Filter
Top Products
5-3
Installation and Upgrade Guide for the Cisco Secure Access Control System 5.2
OL-21574-01
Chapter 5 Installing and Configuring the Cisco Secure Access Control System with CSACS-1121
Installing the ACS Server
Note You can interrupt the setup process at any time by typing Ctrl-C before the last setup value is entered.
Table 5-1 Network Configuration Parameters
Prompt Default Conditions Description
Host Name localhost First letter must be an ASCII character.
Length must be from 3 to 15 characters.
Valid characters are alphanumeric (A-Z,
a-z, 0-9), hyphen (-), and the first
character must be a letter.
Enter the hostname.
IPV4 IP Address None, network specific Must be a valid IPv4 address between
0.0.0.0 and 255.255.255.255.
Enter the IP address.
IPv4 Netmask None, network specific Must be a valid IPv4 address between
0.0.0.0 and 255.255.255.255.
Enter a valid netmask.
IPv4 Gateway None, network specific Must be a valid IPv4 address between
0.0.0.0 and 255.255.255.255.
Enter a valid default gateway.
Domain Name None, network specific Cannot be an IP address.
Valid characters are ASCII characters, any
numbers, hyphen (-), and period (.).
Enter the domain name.
IPv4 Primary Name
Server Address
None, network specific Must be a valid IPv4 address between
0.0.0.0 and 255.255.255.255.
Enter a valid name
server address.
Add/Edit another
nameserver
None, network specific Must be a valid IPv4 address between
0.0.0.0 and 255.255.255.255.
To configure multiple name
servers, enter
Y.