Filter
Top Products
3-5
Cisco H.323 Signaling Interface User Guide
OL-4806-01 Rev. A14
Chapter 3 Provisioning the Cisco HSI
Cisco HSI Configuration
Table 3-3 Static System Data Parameters
Parameter Type Description
HOST_PORT_NUMBER1 [0-65535] The first port number to be used by the Cisco HSI. The default value is 0.
Note This value must match the peer port setting on the PGW
1
2200
E-ISUP IPLNK object.
HOST_PORT_NUMBER2 [0-65535] The second port number to be used by the Cisco HSI. The default value is 0.
Note This value should always be set to 0.
VSCA_IPADDR1 STRING The primary IP address of the primary PGW 2200.
VSCA_IPADDR2 STRING The secondary IP address of the primary PGW 2200.
Note This value must match that of VSCA_IPADDR1.
VSCB_IPADDR1 STRING The primary IP address of the secondary PGW 2200.
Note This parameter is not used in a standalone PGW configuration.
VSCB_IPADDR2 STRING The secondary IP address of the secondary PGW 2200.
Note The value of this parameter must match that of VSCB_IPADDR1.
This parameter is not used in a standalone PGW configuration.
VSCA_PORT_NUMBER1 [0-65535] The first port number of the primary PGW 2200.
VSCA_PORT_NUMBER2 [0-65535] The second port number of the primary PGW 2200.
Note This value must match that of VSCA_PORT_NUMBER1.
VSCB_PORT_NUMBER1 [0-65535] The first port number of the secondary PGW 2200.
Note This parameter is not used in a standalone PGW configuration.
VSCB_PORT_NUMBER2 [0-65535] The second port number of the secondary PGW 2200.
Note The value of this parameter must match that of
VSCA_PORT_NUMBER2. This parameter is not used in a
standalone PGW configuration.
ClipClirSupported STRING CLI Presentation or restriction is enabled if this parameter is present and set to
anything other than “”. For example, to enable CLIP/CLIR support, set this
parameter explicitly to “Enabled.”
RaiSupported STRING RAI support is enabled if this parameter is present and set to anything other than
“”. For example, to enable RAI support, set this parameter to “Enabled.”
DtmfSupportedDirection STRING This is set to “both”, “tx,” or “rx”. If this parameter is not present or is set to any
value other than “both,” “tx,” or “rx,” the DTMF Relay feature is disabled.
DtmfSupportedType STRING This is set to “dtmf” or “basicString.” If this parameter is not present or set to
any other value, the DTMF Relay feature is disabled.
H225PavoSupported STRING Pavo support is enabled if this parameter is present and set to anything other than
“”. For example, set it to “Enabled.”
PavoRedirScreeningInd [0-3] The value of the Pavo redirecting number screening indicator. (If this parameter
is not provisioned, the default is Q.931 zero—user provided, not screened.)
PavoRedirReason [0-15] The value of the Pavo redirecting number reason field. This parameter has no
default. If unprovisioned, the redirecting number parameter will not contain the
Reason for Redirection field (octet 3b).