Filter
Top Products
Cisco IOS Voice Features on IGX 8400 Series Universal Router Module
Command Reference
15
Cisco IOS Release 12.1(5)YA
! Configurations on URM2
ip routing
isdn switch-type primary-qsig
controller T1 2/0
framing esf
linecode b8zs
pri-group timeslots 1-24
no shutdown
interface fastethernet 1/0
ip address 23.0.0.2 255.0.0.0
ip route-cache
no shutdown
interface serial 2/0:23
no ip address
isdn switch-type primary-qsig
isdn incoming-voice voice
no cdp enable
dial-peer voice 120 pots
destination-pattern 120678....
port 2/0:0
direct-inward-dial
dial-peer voice 100 voip
destination-pattern 100527....
session target ipv4:23.0.0.1
codec g729r8
Command Reference
There are no new or modified commands on the Cisco IGX 8400 URM. All IOS commands used on the
module are documented in the Cisco IOS Release 12.1 command reference publications, and in the
documents listed in the “Additional Voice Feature Documentation” section on page 4.