Filter
Top Products
Cisco IOS Voice Features on IGX 8400 Series Universal Router Module
Configuration Examples
7
Cisco IOS Release 12.1(5)YA
Configuration Examples
This section provides the following configuration examples:
• Configuring CAS Calls Over VoATM, page 7
• Configuring QSIG Calls Over VoATM, page 8
• Configuring CAS Calls Using VoIP Over ATM Example, page 9
• Configuring QSIG Calls Using VoIP Over ATM, page 11
• Configuring CAS Calls Over VoIP, page 13
• Configuring QSIG Calls Over VoIP, page 14
Note IP addresses and host names used in these examples are fictitious.
Configuring CAS Calls Over VoATM
The following example shows how to configure voice over ATM channel associated signaling (CAS)
calls on the Cisco IGX 8400 Series Universal Router Module. Voice over ATM enables a URM to carry
voice traffic (for example, telephone calls and faxes) over an ATM network by using ATM encapsulation
ATM adaptation layer (AAL) 5. AAL2 is not supported.
! Configurations on URM1
controller T1 2/0
framing esf
linecode b8zs
ds0-group 0 timeslots 1-24 type e&m-wink-start
no shutdown
interface ATM 0/0
pvc 10/61
vbr-rt 1536 768 192
encapsulation aal5mux voice
dial-peer voice 100 pots
destination-pattern 100527....
port 2/0:0
dial-peer voice 120 voatm
destination-pattern 120678....
session target atm0/0 pvc 10/61
codec g729r8