Filter
Top Products
11
Cisco M SFS7000E Installation Note: InfiniBand Blade Switch for the Dell Modular Server Chassis
78-18371-01
Removing the Cisco M SFS7000E InfiniBand Switch
Removing the Cisco M SFS7000E InfiniBand Switch
To remove the Cisco M SFS7000E InfiniBand Switch, perform the following steps:
Step 1 Disconnect any cables attached to the Cisco M SFS7000E InfiniBand Switch.
Step 2 Press the release latch upward so the switch handle springs open partially.
Step 3 Rotate the switch handle all the way down to eject the switch.
Step 4 Slide the switch out of the chassis bay.
Step 5 Install the I/O connector cover on the switch.
Note When you remove a switch, you must either replace it with an identical switch or a blank IOM within
one minute of removal.
Connecting InfiniBand Cables
This section describes briefly how to connect your IB cables.
Use IB cables to connect your Cisco M SFS7000E InfiniBand Switch. To plug in an IB cable, push the
connector into the interface. For the pull connector, push the latch until it is engaged after it is in the
interface. An alternative method to plug in a pull connector IB cable is to push the latch first, and then
insert the connector until you hear a click. (See Figure 7 and Figure 8.)
Figure 7 InfiniBand Cable with Pinch Connector
2
50421