Cisco Systems MWR 1941-DC-A Network Router User Manual


 
47
Cisco Regulatory Compliance and Safety Information for the Cisco MWR 1941-DC-A Mobile Wireless Edge Router
OL-7870-03
Translated Safety Warnings
Statement 1048—Rack Stabilization
Varning!
Förhindra att systemet överhettas genom att inte använda det på en plats där den rekommenderade
omgivningstemperaturen överstiger
55°C (131°F)
55°C (131°F)
55°C (131°F)
55°C (131°F)
Warning
Stability hazard. The rack stabilizing mechanism must be in place, or the rack must be bolted to the
floor before you slide the unit out for servicing. Failure to stabilize the rack can cause the rack to
tip over.
Waarschuwing
Kantelgevaar. Als u een eenheid uitschuift ten behoeve van service-werkzaamheden, moet het rek
met de speciaal daarvoor bedoelde voorzieningen zijn gestabiliseerd of met bouten in de vloer zijn
vastgezet. Het rek kan kantelen als het niet afdoende is gestabiliseerd.
Varoitus
Stabiiliusvaara. Telineen stabilointimekanismin on oltava paikallaan tai telineen on oltava ruuvattu
lattiaan, ennen kuin liu'utat yksikön ulos huoltoa varten. Ellei telinettä stabiloida, se voi kaatua.
Attention
Stabilisation de l'armoire : le mécanisme de stabilisation doit être installé correctement ou
l'armoire doit être solidement fixée au sol avant d'être utilisée. Sans cette précaution, elle risque
de basculer.
Warnung
Umstürzgefahr. Bevor Sie die Einheit zur Wartung hinausziehen, sollten Sie die
Stabilisierungsvorrichtung des Gestells aktivieren oder das Gestell am Boden festschrauben. Wenn
das Gestell nicht entsprechend gesichert ist, kann es umkippen.
Figyelem!
Borulásveszély! Mielõtt karbantartás céljából kihúzná a készüléket, gyõzõdjön meg róla, hogy fel
van szerelve a rack stabilizáló mechanikája, vagy a rack oda van csavarozva a padlóhoz. Ha a rack
nincs megfelelõen stabilizálva, felborulhat.
Avvertenza
Pericolo di stabilità. Prima di estrarre l’unità per la manutenzione, accertarsi che il meccanismo di
stabilizzazione del rack sia in funzione oppure che il rack sia affrancato al pavimento. La mancata
stabilità del rack può causarne il rovesciamento.