Filter
Top Products
Setting up the Hardware
Step 2 — Install the Ethernet Link
NSS2000 Getting Started Guide 6
2
Step 2 — Install the Ethernet Link
After the disk drives are installed in the chassis, you are ready to connect the
Ethernet cable.
To connect the Ethernet cable to the NSS:
STEP 1 Install the Ethernet cable to the Ethernet port at the back of the NSS chassis.
STEP 2 Connect the Ethernet cable to your network.
Make sure all the connections are secure. You are now ready to continue with
Step 3 — Install the Power.
NOTE: If you are hotplugging an Ethernet
cable to the NSS after the initial installation,
ensure you wait 15 seconds between the time
you unplug the cable and plug it back in. Within
10 seconds the newly connected link should
appear with the correct IP and link rate in the
configuration interface.