Filter
Top Products
4
Release Notes for Cisco Wireless LAN Controllers and Lightweight Access Points for Release 3.2.171.6
OL-11567-02
Installation Notes
Warning
Do not locate any antenna near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. When installing antennas, take extreme care not
to come in contact with such circuits, as they may cause serious injury or death. For proper
installation and grounding of the antenna, refer to national and local codes (e.g. U.S.: NFPA70,
National Electrical Code, Article 810, in Canada: Canadian Electrical Code, Section 54).
Warning
This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that
the protective device is rated not greater than 120 VAC, 15A U.S. (240vac, 10A International).
Warning
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground connector. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available.
Warning
Read the installation instructions before you connect the system to its power source.
Warning
Do not work on the system or disconnect cables during periods of lightning activity.
Warning
Do not operate your wireless network near unshielded blasting caps or in an explosive environment
unless the device has been modified to be especially qualified for such use.
Warning
In order to comply with radio frequency (RF) exposure limits, the antennas for this product should be
positioned no less than 6.56 ft (2 m) from your body or nearby persons.
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security.
Safety Information
Follow the guidelines in this section to ensure proper operation and safe use of the controllers and access
points.
FCC Safety Compliance Statement
FCC Compliance with its action in ET Docket 96-8, has adopted a safety standard for human exposure
to RF electromagnetic energy emitted by FCC certified equipment. When used with approved Cisco
Aironet antennas, Cisco Aironet products meet the uncontrolled environmental limits found in OET-65
and ANSI C95.1, 1991. Proper operation of this radio device according to the instructions in this
publication results in user exposure substantially below the FCC recommended limits.