Filter
Top Products
3-17
Cisco Access Router Manager User Guide
OL-3597-01
Chapter 3 Deploying and Discovering Objects
Deployment
Step 6 Click Forward.
You are prompted to repeat Step 5 if you are deploying more than one chassis.
Deployment summary details appear in the Deployment Wizard – Summary window.
Figure 3-15 Deployment Wizard—Summary
The number of objects deployed is equal to the number of chassis entered in Step 3. This entry directly
correlates to the number of objects listed in the deployment summary information.
Step 7 Click Finish to deploy the chassis and close the summary window if the deployment summary
information is correct. If the Deployment Summary information is incorrect, click Cancel to stop
deployment and close the summary window.
The deployed chassis object(s) appear in the left–hand pane of the Map Viewer beneath the generic
object from which deployment was initiated and the corresponding icon(s) appear in the right–hand pane
of the Map Viewer.
Commissioning activities start with chassis discovery. If successful, the chassis moves into the
appropriate managed state then initiates subchassis discovery which begins to detect the physical objects
(that is, modules and interfaces) within the chassis and places them onto the chassis map. Modules and
interfaces are automatically named as described in the “Automatically Discovering Modules” section on
page 3-3. Following subchassis discovery, all objects enter a specific state. For further information, see
the “Object States” section on page 1-23.
Successful commissioning not only discovers the chassis and all the physical objects within the chassis,
but also initiates heartbeat polling, which allows alarms to be raised on the chassis and all physical
objects within the chassis.
Commissioning automatically starts active management (such as polling) on the chassis and all
commissioned objects within the chassis. There is no indicator regarding the success or failure of the
quick start commission. To optionally check the outcome of the commission, review the status of the Last
Commission field on the Chassis Configuration window. For further information on the Chassis