Filter
Top Products
3-3
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide
OL-4211-07
Chapter 3 Installing the Client Adapter
Inserting a Client Adapter
Step 4 If the Found New Hardware Wizard window appears, click Cancel.
Note If you do not click Cancel, the wizard will attempt to install software for the client adapter but
will be unable to find it.
Step 5 Go to the “Installing the Client Adapter Software” section on page 3-9.
Inserting a PCI Card
You must perform the following procedures in the order listed below to insert a PCI card:
• Change the bracket (if required), see below
• Insert the card, page 3-4
• Assemble the antenna, page 3-5
• Mount the antenna, page 3-6
Changing the Bracket
The PCI card is shipped with a full-profile bracket attached. If the PC into which you are inserting the
PCI card requires the card to use a low-profile bracket, follow these steps to change brackets.
Step 1 Remove the two screws that attach the bracket to the card. See Figure 3-2.
Figure 3-2 Changing the PCI Card Bracket
95581
STATUS
ACTIVITY
1
1
1
Bracket screws