Filter
Top Products
xvii
Cisco MGX Route Processor Module (RPM-XF) Installation and Configuration Guide
OL-13644-01
About This Guide
This section describes the objectives, audience, organization, and conventions of the Cisco MGX Route
Processor Module (RPM-XF) Installation and Configuration Guide, Release 5.5.00.
Objectives
This publication provides instructions for the initial site preparation and installation of the
Cisco MGX Route Processor Module (RPM-XF). Troubleshooting, maintenance procedures, and cable
specifications are also provided.
Only basic software configuration information is included in this publication. For detailed software
configuration information, refer to the Cisco MGX 8850 and Cisco IOS configuration and command
reference publications. These publications are available on the Documentation CD-ROM that comes
with your RPM-XF, or you can order printed copies.
Audience
This document was written for engineers, users, network administrators, and technicians that are familiar
with Cisco MGX Series switches and Cisco routers. Readers should be familiar with electronic circuitry
and wiring practices.
Changes to this Document
Table 1 summarizes the changes made to this document since the previous release.
Table 1 Changes to This Guide Since the Previous Release
Section and Link Status Description
Chapter 9, “Configuring MPLS Features” Added
• Added new section: Marking a GRE Tunnel Header for
Multicast Traffic, page 19.