Filter
Top Products
10
Release Notes for Cisco SN 5428-2 Storage Router, Release 3.5.1
OL-5241-02
New CLI Commands
• clear debug: Removes an iSCSI trace capture from system memory.
• debug iscsitrace default: Sets the default iSCSI trace parameters.
• debug scsirouter target iscsitrace: Enables trace facilities for debugging iSCSI connections on a
per-target basis.
• show debug iscsitrace defaults: Displays the default PDU and trace buffer size to be used for iSCSI
tracing.
• slp enable: Enables Service Location Protocol (SLP) service on the storage router.
Modified CLI Commands
• fcip destination config: The usesack and pacingrate keywords were added, the idlepingdelay
default was changed to 15, and the default TCP receive window (rxtcpwinsize) was increased to
1048576.
• restore system: The slp and rip keywords were added, and RIP settings were removed from the
ip-route keyword.
• show debug scsisouter: The show debug scsirouter target iscsitrace command syntax was added
Limitations and Restrictions on SN 5428-2 Storage Router
Clusters
This release includes the following restrictions on SN 5428-2 Storage Router clusters:
• A cluster can be composed of up to two SN 5428-2 Storage Routers, or one SN 5428-2 and one
SN 5428 Storage Router.
• A cluster can support up to 12 SCSI routing instances.
• A cluster can support up to 100 iSCSI targets.
Caveats
Caveats describe unexpected behavior or defects in the specified SN 5428-2 software release. Severity 1
caveats are the most serious caveats; severity 2 caveats are less serious.
This document describes open and resolved severity 1 and 2 caveats and selected caveats of other
severities, for release 3.5.1.
• The “Open Caveats” section lists caveats that are open in the current release and may be open in
previous releases.
• The “Resolved Caveats” section lists caveats that are resolved in this release, but open in previous
releases.
Within the sections, the caveats are sorted alphanumerically by caveat number.