Filter
Top Products
18
Installing the Cisco WAE Inline Network Adapter
OL-12480-03
Installing Adapters in the WAE-7326 Appliance
Removing the Cover
Warning
Before working on a system that has an on/off switch, turn OFF the power and unplug the power cord.
Statement 1
To remove the device top cover, follow these steps:
Step 1 Review the information in the “Safety Guidelines” section on page 5.
Step 2 Power off the device and all attached devices and disconnect all external cables and power cords.
Step 3 Press down on the left and right side latches and pull the device out of the rack enclosure until both slide
rails lock.
Note You can reach the cables on the back of the device when the device is in the locked position.
Step 4 Lift the cover-release latch (labeled 1 in Figure 11). Lift the cover off the device and set the cover aside.
Figure 11 Removing the Cover
Caution For proper cooling and airflow, replace the cover before turning on the device. Operating the device for
extended periods (over 30 minutes) with the cover removed might damage device components.
159947
1