Filter
Top Products
22
Installing the Cisco WAE Inline Network Adapter
OL-12480-03
Installing Adapters in the WAE-7371, WAE-7341, and WAE-674 Appliances
Installing Adapters in the WAE-7371, WAE-7341, and WAE-674
Appliances
This section describes how to install the inline network adapter in the WAE-7371, 7341, and 674
appliances. This section includes the following procedures:
• Removing the Cover
• Installing an Inline Network Adapter
• Completing the Installation
Removing the Cover
Warning
Before working on a system that has an on/off switch, turn OFF the power and unplug the power cord.
Statement 1
To remove the device top cover, follow these steps:
Step 1 Review the information in the “Safety Guidelines” section on page 5.
Step 2 Power off the device and all attached devices and disconnect all external cables and power cords.
Step 3 Press down on both side latches and pull the device out of the rack enclosure until both slide rails lock.
Note You can reach the cables on the back of the device when the device is in the locked position.
Step 4 Lift the cover-release latch (see Figure 15). Lift the cover off the device and set the cover aside.
Figure 15 Removing the Cover
Cover-release latch
185089