Filter
Top Products
12
Installing the Cisco WAE Inline Network Adapter
OL-12480-03
Installing Adapters in the FE-511, WAE-511, and WAE-611 Appliances
Step 10 Reinstall the riser card. Make sure that the riser card is fully seated in the riser card connector (labeled
6 in Figure 5) on the system board.
Step 11 Tighten the captive screw for expansion slot 1.
Step 12 Connect the required cables to the adapter.
Completing the Installation
To complete your installation, reinstall the cover and reconnect all cables that you disconnected earlier.
Caution To maintain proper cooling and airflow, install the cover before turning on the appliance. Operating the
appliance for extended periods (over 30 minutes) with the cover removed might damage internal
components.
To install the cover, follow these steps:
Step 1 Install the cover by placing it into position and sliding it forward, and then tighten the captive screws
(labeled 1 in Figure 6).
Caution Before sliding the cover forward, make sure that the cover will properly engage the ledge at the front of
the appliance.
Figure 6 Installing the Cover
Step 2
Install the appliance in the rack.
115802
1