Filter
Top Products
3
Catalyst 6500 Series PFC3B and PFC3BXL Installation Note
78-16220-02
Parts List
Warning
Blank faceplates and cover panels serve three important functions: they prevent exposure to
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place.
Statement
1029
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Parts List
These parts are in the WS-F6K-PFC3B= or WS-F6K-PFC3BXL= kit:
• One Catalyst 6500 series PFC3B or PFC3BXL
• One packet of labels
• One disposable grounding wrist strap
• One bag of mounting screws
• Two 1-GB DRAM DIMMs (to be installed on the Supervisor Engine 720 switch processor and
route processor) — PFC3BXL only
Required Tools
Note In this section, the term "PFC3B" refers to the PFC3B and PFC3BXL unless otherwise noted.
These tools are required to perform the installation of the PFC3B:
• Antistatic mat or foam pad to support the removed Supervisor Engine 720
• 3/16-inch flat-blade screwdriver for the captive installation screws on the Supervisor Engine 720
• Number 1 Phillips screwdriver for the screws and cap nut that fasten the PFC3B to the
Supervisor Engine 720
• Your own ESD-prevention equipment or the disposable grounding wrist strap included with all
upgrade kits, field-replaceable units (FRUs), and spares