Filter
Top Products
Appendixes
80
z Cut Position Adjustments
• The cut position can be specified with the 'fnnn' of the system-level commands. When the tear-off
function is turned on, the following initialization value is set in the printer.
Initialization value: fnnn = f735 (73.5 mm)
The values higher or lower will increase or decrease the amount of feed in the tear-off.
• Parameter initialization values
Initialization values of print and feed positions by each operating mode are described below.
If values lower than the minimum values are set, the initialization values will be set instead. (When
the virtual distance between the print and feed positions' mode is on.)
2 Specifications