Filter
Top Products
Camera Care
12
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Camera Care
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Camera lens and lens holder
The camera lens is held in place by the lens holder. Both are permanently attached to
the camera head. Do not try to rethread or unscrew the lens holder.
Gooseneck
Use the gooseneck to adjust the camera head/camera lens over the projected image.
Do not bend the gooseneck more than 90° in any direction or attempt to tie it in a
knot. Do not attempt to repair any cracks in the vinyl coating.The gooseneck is non-
detachable and should be replaced only by ClearOne.
Warnings
• Do not disassemble or loosen any exterior or interior components of the
camera.
• Any camera lens will be permanently damaged if it is over-tightened.
Operating and storage conditions
Do not store or operate the camera under the following conditions:
• Outdoors or connected to outdoor or auxiliary power sources
• At temperatures above 104°F(40°C) or below 32°F(0°C)
• In environments with high humidity
• In dusty environments
• In inclement weather
• Under severe vibration
13
Handling the camera
• Read and understand all instructions before using.
• Do not operate the camera if the USB cable is damaged or if the camera has
been dropped or damaged. A qualified service technician must examine the
camera before it can be used again.
• Position the cord so that it will not be tripped over, pulled, or come in contact
with hot surfaces.
• Always unplug the camera from the computer before cleaning or servicing.
• To reduce the risk of electric shock, do not immerse in water or other liquids.
• All ClearOne cameras are for indoor use only.
• Do not use cameras next to food or beverages. Cameras have been tested and
approved for use in chemistry labs. However, be very careful not to spill liquid or
dry chemicals, or solvents on the camera.
• Do not place cameras closer than 6' to TVs, radios, motors, transformers, or
magnetic fields.
• Avoid touching the lens.To clear any dust, blow pressurized air onto the lens.
For accidental smears or smudges, wipe carefully with a lens cleaning cloth.
• Clean exterior of camera by wiping with a clean, damp cloth; do not use any
abrasive chemicals.
• Use both hands whenever adjusting the neck of the camera; this will prevent
any unnessary strain on the camera’s base and will keep the camera from tip-
ping over unexpectedly.
• Do not attempt to take the camera apart.There are no user-serviceable com-
ponents inside.
Camera base
The camera base contains five rubber feet for non-slip support of the camera.
Camera head
This pre-assembled unit contains the camera lens, lens holder, focus ring attachments
and is connected to the gooseneck. Do not turn camera head more than 30° left or
30° right.
Camera Care