Filter
Top Products
Hard drive
1. Remove the 4 Phillips PM3.0×3.0 screws (1) that secure the hard drive bracket to the hard drive.
2. Using the Mylar tab, lift the bracket (2) away from the hard drive.
Reverse this procedure to install a hard drive.
Solid-state drive
To remove the solid-state drive:
1. Remove the 4 Phillips PM2.0×3.0 screws (1) that secure the solid-state drive bracket to the solid-
state drive.
2.
Lift the solid-state drive (2) to remove it.
Reverse this procedure to install a solid-state drive.
Component replacement procedures
45