Filter
Top Products
5. Select the option to view the device list.
A list of the installed hardware devices is displayed.
NOTE: Computer Checkup does not detect all non-Compaq devices.
6. Verify that Computer Checkup correctly detected the installed devices.
If the list is correct, select OK. The Computer Checkup option menu is
displayed again.
If the list is incorrect, verify that the new devices are installed
properly.
7. Select one of the following from the test option menu:
- Quick Check Diagnostics -- This option runs a quick, general test on
each device with a minimal number of prompts. If errors occur, they
are displayed when the testing is complete.
- Automatic Diagnostics -- This option runs an unattended, maximum
test of each device with minimal prompts. You can choose how many
times to run the tests, to stop on errors, or to print or file a log
of errors.
- Prompted Diagnostics -- This option allows maximum control over the
device testing process. You can choose attended or unattended
testing, decide to stop on errors, or choose to print or file a log
of errors.
8. Follow the instructions on the screen as the diagnostic tests are run
on the devices.
When the testing is complete, the test option menu is displayed again.
9. Exit the test option menu.
10. Exit the Configuration and Diagnostics menu.
NOTE: Exiting the Configuration and Diagnostics menu restarts the
computer and saves your changes.
11. Look up the Computer Checkup error codes that were displayed by
referring to "Computer Checkup (TEST) Error Codes" and take the
recommended action.
12. Rerun POST and Computer Checkup, taking the recommended actions in
given order until the problem is solved and no error messages occur.
Computer Checkup (TEST) Error Codes
Computer Checkup (TEST) error codes (Section 5.2) occur if the system
recognizes a problem while running Computer Checkup. These error codes