Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Removal and Replacement Procedures 5-5
5.3.2 Undocking the Computer
If the computer is docked in an auxiliary station, it must be undocked from the
convenience base and from the adapter or detached from the Mobile CD Expansion
Unit (MCD) before performing additional work. Complete the following steps to
undock the computer. If the computer is not docked in an auxiliary station, proceed to
Section 5.3.3.
Convenience Base
The computer must be undocked from the convenience base before performing
additional work. The same procedure is followed for removing the adapter and
removing the MCD from the convenience base. These procedures are shown in Figures
5-4 and 5-5, respectively. To remove and replace the convenience base, complete the
following steps:
1. Disconnect the AC power and any external devices (Section 5.3.1).
2. Close the computer.
If you are removing an adapter from the convenience base proceed with step 3. If
detaching an MCD, go to step 5.
3. Grasp the adapter and the convenience base and lift the convenience base slightly to
disengage it from the adapter.
4. Pull the two pieces apart.