Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5-18 Removal and Replacement Procedures
5.3.5 Hard Drive
The hard drive is held in place with two screws. To remove the hard drive, complete the
following steps:
1. Disconnect the AC power (section 5.3.1).
2. Undock the computer from its auxiliary base, if necessary (See Section 5.3.2).
3. Remove the handle battery pack (Section 5.3.3).
4. Remove the modular battery pack, if present (Section 5.3.4).
5. Remove the two screws
1
from the bottom of the computer that secure the hard
drive in place.
6. Grasp the hard drive at the thumb tab
2
and slide it straight out of the computer.
Figure 5-16.
Removing the Hard Drive
Reverse the above procedure to install the hard drive.