Filter
Top Products
On the back of the monitor three kinds of plug-in connec-
tions are provided: AC power connector for the AC input,
two DB9-15P connectors for video signal input, and USB
ports for USB communication.
3.1 AC Power Connection
One end of the AC power cord is connected to the AC
power connector on the back of the monitor. The other end
is plugged into a properly grounded three-prong AC outlet.
The monitor’s auto-sensing power supply can automati-
cally detect 100-120V AC or 220-240V AC and 50 or 60Hz.
3.2 Signal Cable Connection
The DB9-15P(VGA) connector is provided for compatible
analog RGB outputs from your computer.
3.2.1 Connection to VGA Compatible System
Figure 5 shows the SC-B110 cable connection to the Video
Graphics Array (VGA) port.
1. Power off, both the monitor and the computer.
2. Connect the one end of the SC-B110 cable to the
DB9-15P connector on the VGA controller card.
3. Connect the other end of the SC-B110 cable to the
DB9-15P receptacle on the back of the monitor.
4. Power on the monitor, then the computer.
5. After using the system, power off the monitor, then
the computer.
The socket-outlet shall be installed near the equipment
and shall be easily accessible. During servicing, discon-
nect the plug from the socket-outlet.
3 INSTALLATION AND
CONNECTION
Figure 5