Compaq ES40 Server User Manual


 
Linux Installation and Configuration Guide for AlphaServer 38
ECG513/0100
Password: user@
ftp> bin
ftp> cd /pub/DEC/Linux-Alpha/Images/
ftp> get generic-smp-2.2.12.img
ftp> quit
2. Insert a blank, formatted floppy into the computer, and copy the BOOT kernel to it:
$ dd if=generic-smp-2.2.12.img of=/dev/fd0
With this floppy in hand, you are now prepared to begin the installation process on your
AlphaServer or AlphaStation.
Firmware Inspection and Upgrade
After powering up your AlphaServer or AlphaStation computer, type the command "show
version". Check that the version string printed is "V5.4-2 May 19 1999 14:25:16" or newer, and
that the first letter of the version string is a "V". If this is not the case, you should upgrade your
firmware. Instructions on how to do this can be found at
http://ftp.digital.com/pub/Digital/Alpha/firmware/ along with the latest firmware images.
System Resource Manager Configuration
There are several pieces of information that you need to configure in the SRM subsystem, as well
as device identifiers that you should make note of, prior to beginning the installation process. The
steps that follow take you through that process.
1. Power up your system. After several diagnostics are completed, you will be presented an
SRM prompt "P00>>>", as shown here:
256 Meg of system memory
probing hose 1, PCI
bus 0, slot 9 -- ewa -- DE500-AA Network Controller
probing hose 0, PCI
probing PCI-to-ISA bridge, bus 1
bus 0, slot 5, function 1 -- dqa -- Cypress 82C693 IDE
bus 0, slot 5, function 2 -- dqb -- Cypress 82C693 IDE
bus 0, slot 6, function 0 -- pka -- Adaptec AIC-7895
bus 0, slot 6, function 1 -- pkb -- Adaptec AIC-7895
bus 0, slot 7 -- vga -- ELSA GLoria Synergy
os_type: UNIX - console CIPCA driver not started
System Temperature is 30 degrees C
initializing GCT/FRU at 1ec000
COMPAQ AlphaServer DS20E 500 MHz Console V5.5-21, Oct 18 1999 13:33:24
P00>>>
2. Determine what devices your system has installed. In particular you will need to note your
installation device (a floppy and/or CD-ROM), and your target disk drive. Entering the
command "show devices" as shown below will print out the information about your system:
P00>>>show device
dka0.0.0.6.0 DKA0 COMPAQ BA03611C9B 3B05
dka100.1.0.6.0 DKA100 COMPAQ BB01811C9C 3B05
dka200.2.0.6.0 DKA200 COMPAQ BB01811C9C 3B05
dqa0.0.0.105.0 DQA0 CD-224E 9.5B
dva0.0.0.0.0 DVA0
ewa0.0.0.9.1 EWA0 00-00-F8-01-F5-DA
pka0.7.0.6.0 PKA0 SCSI Bus ID 7
pkb0.7.0.106.0 PKB0 SCSI Bus ID 7