Filter
Top Products
Linux Installation and Configuration Guide for AlphaServer 52
ECG513/0100
bus 0, slot 1 -- vga -- ELSA GLoria Synergy
bus 0, slot 15 -- dqa -- Acer Labs M1543C IDE
bus 0, slot 15 -- dqb -- Acer Labs M1543C IDE
starting drivers
entering idle loop
initializing keyboard
starting console on CPU 1
initialized idle PCB
initializing idle process PID
lowering IPL
CPU 1 speed is 500 MHz
create powerup
starting console on CPU 2
initialized idle PCB
initializing idle process PID
lowering IPL
CPU 2 speed is 500 MHz
create powerup
starting console on CPU 3
initialized idle PCB
initializing idle process PID
lowering IPL
CPU 3 speed is 500 MHz
create powerup
Memory Testing and Configuration Status
Array Size Base Address
--------- ---------- ----------------
0 512Mb 0000000100000000
1 2048Mb 0000000000000000
2 1024Mb 0000000080000000
3 1024Mb 00000000c0000000
4608 MB of System Memory
Testing the System
Testing the Disks (read only)
Testing the Network
Partition 0, Memory base: 000000000, size: 120000000
initializing GCT/FRU at 1a2000
AlphaServer ES40 Console V5.5-68, built on Jul 21 1999 at 17:02:39
P00>>>
2. Determine what devices your system has installed. In particular you will need to note your
installation device (a floppy and/or CD-ROM), and your target disk drive. Entering the
command "show devices" as shown below will print out the information about your system:
P00>>>show dev
dka0.0.0.4.1 DKA0 RZ2ED-LS 0306
dka100.1.0.4.1 DKA100 RZ2DD-LS 0306
dka200.2.0.4.1 DKA200 RZ2DD-LS 0306
dka300.3.0.4.1 DKA300 RZ2DD-LS 0306
dqa0.0.0.15.0 DQA0 COMPAQ CDR-8435 0013
dva0.0.0.1000.0 DVA0
ewa0.0.0.6.1 EWA0 08-00-2B-C4-56-8E
pka0.7.0.4.1 PKA0 SCSI Bus ID 7
In the output above, the first line shows that DKA0 is a hard disk, DQA0 is a CD-ROM, and
DVA0 is a floppy drive.
Also useful for inspecting the computer configuration is the "show config" command, as
shown here:
P00>>>show config | more