Filter
Top Products
6. Remove the WLAN antenna cables (3) from the routing channel and clips built into the top cover.
7. Disconnect the microphone cable (4) from the microphone pass-through cable.
8. Disconnect the display lid switch module cable (1) from the system board.
9. Remove the two Torx T8M2.5×7.0 screws (2) that secure the display assembly to the computer.
10. Lift the display assembly straight up and remove it (3).
11. If it is necessary to replace the display lid switch module, remove the Phillips PM1.5×3.0 screw
(1) that secures the module to the display assembly left hinge.
12. Rotate the module (2) ¼-turn counterclockwise.
Component replacement procedures 63