Filter
Top Products
QuickSpecs
StorageWorks NAS B3000 by Compaq
DA-11339 Canada — Version 7 — September 24, 2002 4
Standard Features
Processor
Model N900, C900, N900s, C900s
Two (2) Intel Pentium III Xeon 900-MHz processors (upgradeable to 4)
Cache Memory
2-MB level 2 write back cache per processor standard
Memory
Standard 2 GB (512 x 4 PC100MHz ECC SDRAM Memory with Advanced ECC functionality)
Maximum 4 GB
NOTE: Advanced ECC Memory Technology protects the data even in the event of an entire SDRAM component
failure. Embedded in the chipset design, this feature allows the use of Industry-Standard Registered
DIMMs.
Upgradability
Upgradeable to four processors, upgradeable to 4 GB of ECC SDRAM, upgradeable storage capacity
Network Controller
Integrated Compaq NC3134 Fast Ethernet NIC 64 PCI Dual Base 10/100 in a slot and a Compaq NC3135 Fast
Ethernet NIC 64 PCI dual 10/100 daughter card (total 10/100 ports is 4) (Gigabit options available)
Host Adapters
FCA2101 Host Bus Adapter
Expansion Slots
I/O (6 Total, 2 Available) PCI Voltage:
Two (2) 64-bit/66-MHz PCI Hot Plug 1 available 3.3 Volt Only
Two (2) 64-bit/33-MHz PCI Hot Plug 0 available 5 Volt or 3.3 Volt
One (1) 64-bit/33-MHz PCI Non-Hot Plug 0 available 5 Volt or 3.3 Volt
One (1) 32-bit/33-MHz PCI Non-Hot Plug 1 available 5 Volt Only
NOTE: One 64-bit/66-MHz PCI Hot Plug slot available and one 32-bit/33-MHz PCI Non-Hot Plug slot available
Storage Controller
Integrated Smart Array Controller (Two channel) (supports Internal RAID 0, 1, 0+1, 5 and external tape devices)
Internal Storage
Diskette Drives 1.44 MB
CD-ROM 24x IDE CD-ROM Drive (slim line)
Hard Drives Two 1″ 36.4-GB Ultra3 10K rpm hot plug drives (contain operating system in a
RAID 1 configuration)
Maximum Internal Storage 78.2 GB (2 x 36.4-GB Wide Ultra3 1″ drives)
External Storage
Minimum External Storage MSA1000
(
4
(
for non-clustered
)
to 6
(
for clustered
)
x 72-GB drives dependin
g
on
model)
Interfaces
Parallel Not supported
Serial 1
NOTE: You can configure a second serial device to your NAS B3000 server by
installing the auxiliary serial connector that ships with the server. The
auxiliary connector attaches to a serial port B on the peripheral board
and exits the rear of the server through the auxiliary serial knockout
located directly above the dual power feeds.
Pointing Device (Mouse) 1
Graphics Available through the “Remote Insight Board” only
Hot Plug Keyboard 1
External Wide Ultra2 SCSI 1