Filter
Top Products
BIOS
Page 4-13
Doze Mode: The Doze mode timer starts to count when no PM events have
occurred.
Suspend Mode: This function works only when the Pentium II Processor is
installed. The timer starts to count when System Standby mode timer is timed
out and no PM Events are occurring. Valid range is from 1 minute up to 1 hour.
HDD Power Down: HDD Standby timer can be set from 1 to 15 minute(s).
Soft-Off by PWRBTN: Use this to select your soft-off function.
The default is Delay 4 sec.
Instant Off: Turns off instantly.
Delay 4 Second: Turns off after a 4 second delay. If momentary press of button,
the system will go into Suspend Mode. Press again to take
system out of Suspend Mode.
PWRON After PW-Fail: The system will stay of or power on after a power
interrupte. The default is OFF.
Fomer-Status: Stay off or power on depend on system safe shut-down or power
fail.
ON: System always power on after a power interrupte.
OFF: System always stay off after a power interrupte.
VGA: When set to On (default), any event occurring at a VGA port will awaken a
system which has been powered down.
LPT & COM: When set to On (default), any event occurring at a COM(serial)/
LPT (printer) port will awaken a system which has been powered down.
HDD & FDD: When set to On (default), any event occurring at a hard or floppy
drive port will awaken a system which has been powered down.
DMA/master: When set to On (default), any event occurring to the DMA control-
ler will awaken a system which has been powered down.
RTC Alarm Resume: When set to Enable rta alarm resume, you could set the
date (of month) and timer (hh:mm:ss), any event occurring at will awaken a system
which has been powered down.