Filter
Top Products
4-4 CHAPTER 4: STANDARD INSTALLATION AND CONFIGURATION
4 Select the Auto Configure 3Com PC Card Adapter option,
as shown in Figure 4-2, and press [Enter].
This step configures the I/O Base Address and the Interrupt
Request Level to settings that do not conflict with any other
device on your computer.
The Select Ring Speed screen appears with 16 Mbps
highlighted as the default speed.
Figure 4-2 Main Menu with Auto Configure Option Selected
5 Select the correct ring speed and press [Enter].
A message appears, telling you the 3C689 adapter has been
configured successfully. The configuration settings are saved
to the NET.PCM and PROTOCOL.PCM files.
The next step is to install the network drivers. If you need to
change the configuration settings before you install the
drivers, follow the steps in the next section. Otherwise,
proceed to Chapter 5, “Installing Network Drivers,” for
instructions on installing the network drivers.
ESC=Cancel F1=Help
TokenDisk for the TokenLink III PC Card Adapter
MAIN MENU
[ENTER]=Execute Function
[
-¯
]=Scroll
[F1]=Help [ESC]=<Cancel>
Auto Installation with Configuration (AutoLink)
NetWare DOS ODI Client
Standard Installation and Configuration
Auto Configure 3Com PC Card Adapter
Network Drivers ...
Configuration/Diagnostic/Troubleshooting ...
General Information/Release Notes
Automatically configures the adapter to non-conflicting settings