Filter
Top Products
Chapter 3 Configuring NetPassage 15B
21
Router Identity as the DHCP Client ID to request for IP release. Refer to
Section 3.8.1 titled Setting Router Identity.
If your NetPassage 15B has previously been configured with other WAN type, you may
re-configure it to support Cable Internet with Dynamic IP Assignment.
1. Click on the WAN Setup URL from the Command Menu and the WAN
configuration page will be displayed, as shown in Figure 3.2.1-1.
Figure 3.2.1-1
Changing WAN Type
NOTE
Figure 3.2.1-1 shows a WAN interface configured with static IP. If
your NetPassage 15B has previously configured with PPPoE or other
WAN type, this page will show the respective configuration page.
2. Press the Change button and the list of supported WAN type will be displayed, as
shown in Figure 3.2.1-2.
Figure 3.2.1-2
Selecting the WAN Type
3. Check the Dynamic IP Address radio button and press the Save button.
4. Press the Reboot button to restart the NetPassage 15B.
Cloning MAC Address to NetPassage 15B
1. Click on the WAN Setup URL from the Command Menu and the WAN
configuration page will be displayed, as shown in Figure 3.2.1-3.