Filter
Top Products
9
9.2.2
Selecting an Input
Input selection on the Matrix Switchers is made by pressing any of the buttons marked “1” through “8” (CVG-
808
XL), or "1" to "6" (CVG-606XL) on the front panel. These buttons correspond to input connections as
marked on the back panel.
9.2.3 Connecting a Video/Audio Input/Output
To connect a video/audio Input to a specific output, press the desired output button (upper line), followed by the
desired input button (lower row).
9.2.4 Disconnecting a Video/Audio Input
To disconnect a video/audio Input from a specific output, press the desired output button followed by the OFF
button. To disconnect all the outputs, press the
ALL
button, followed by the
OFF
button.
9.2.5 Connecting a Video/Audio Input to All Outputs
To connect a video/audio Input to all outputs, press the ALL button followed by the INPUT button
corresponding to the input, which is to be routed to all the outputs.
9.2.6 Selecting Video/Audio Control (Breakaway)
For audio control only, press the AUDIO button. For video control only, press the VIDEO button. Note that the
STATUS
window displays audio or video settings in accordance with the selection.
9.2.7 Using the Audio Follow Video Mode
To select "Audio Follow Video" mode, press the AFV button. Note that if the audio configuration differs from
the video configuration, the differing audio outputs blink in the
STATUS
window of the audio display. The
AUDIO and TAKE buttons blink as well, which means that the audio configuration will be modified for AFV
operation. Press the TAKE button to confirm the modification.
9.2.8
Storing a Configuration
To store a configuration, press the STO button, followed by input or an output button to mark the setup number.
For example, press STO followed by INPUT # 3 button to store the current configuration in Setup # 3 in the
internal non-volatile memory of the switcher. To abort an operation of the
STO
button once it was pressed,
press it again.
9.2.9 Recalling a Configuration
To recall a configuration, press the
RCL
button, followed by an input or an output button, marking the setup
number. For example, press RCL followed by INPUT# 3 button to recall Setup # 3 from the internal non-
volatile memory of the switcher. To abort an operation of the RCL button once it was pressed, press it again.
9.2.10 Deleting a Setup
To delete a setup, press both the STO and the RCL buttons followed by the input button corresponding to the
setup number, which is to be deleted.
9.2.11 Using the Take Function
To activate the "Take" Function, press the TAKE button (the TAKE button illuminates). After each pressing of
the above-mentioned buttons, the TAKE button blinks together with the relevant numbers in the STATUS
display. Confirmation of the action is implemented by pressing the
TAKE
button again (the
TAKE
button then
stops blinking). If the STATUS display keeps on blinking for one minute (no button is pressed), the function
will be aborted. To abort implementing an operation in “Take” mode, press that button which originally caused
the display to blink.
9.2.12 Resetting the Machine
To reset the machine, press INPUTS buttons "1", "2" and "3" simultaneously. The machine resets itself and a 7-
segment self-test is automatically performed.
9.3 Using the Back Panel Controls
The switcher ID numbers, the RS-232 / RS-485 settings, and the sync source selection are all configured on the
back panel of the machine.