Filter
Top Products
Crestron CNRFGWA Wireless RF Receiver
Operations Guide - DOC. 8086A Wireless RF Receiver: CNRFGWA • 9
2. Refer to the figure after this step. From the Viewport menu, select
Setup | Communications settings (alternatively, press Alt+D) to open
the “Port Settings” window.
Setup | Communications Settings Command
3. Select RS-232 as the connection type. Verify that an available COM
port (COM 1 is shown below) is selected, Verify that the baud rate is
set to 38400 (PRO 2 default), the parity is None, the data bits is Eight,
the stop bits is One, XON/XOFF is not selected, and RTS/CTS is
selected. Click the OK button to save the settings and close the
window.
“Port Settings” Window
NOTE: The parameters shown in the illustration above are the port settings for a 2-
Series control system. Consult the Operations Guide for the control system being
used for exact parameter selection.
4. To verify communication, select Diagnostics | Establish
Communications (Find Rack). This should display a window that
gives the COM port and baud rate. If communication cannot be
established, refer to the “Troubleshooting Communications” section in
the respective Operations Guide for the control system.