Filter
Top Products
CyberPower Network Management System
16
Information indicates an event that requires no action.
Warning indicates an event that does not require immediate attention, but this condition should
be monitored.
Severe indicates an event that requires immediate attention.
1. Determine the severity levels and click the option buttons.
2. Click [Apply] to activate the settings.
[UPS Shutdown]: Configures UPS shutdown and PC safe shutdown times.
1. Low-Battery Duration: Time from a Low-Battery signal until load is shutdown.
2. Maximum Shutdown Time: The maximum time the UPS will wait before it shuts down in
response to a turnoff command.
3. Shutdown Delay: Time the UPS will wait before it shuts down in response to a turnoff
command.
Note:
In order to have the PCs connected to the UPS so that they can be shut down safely, add the IP
address of the PCs into Trap Notification. (Reference to Page14.) Install “Power Panel Shutdown
Service” software, and then assign the IP addresses to “Network Management Card”