Filter
Top Products
CyberPower Network Management System
4
INSTALLATION GUIDE
Step 1. Hardware Installation
1. Connect the Ethernet cable to the LAN port of the CyberPower Network Management Card.
2. Connect the CyberPower Network Management Card to the UPS communication port. It
is optional to use the serial cable included.
3. Connect the AC adapter (for select UPS models only) to the Network Management Card
Adapter and plug into the wall socket..
4. After the above procedures are done, press and hold the Reset Button on the Network
Management Card for 7 seconds to ensure the IP Address is at the default value.
Step 2. Configure the IP address for the CyberPower Network Management Card.
Method 1 : Use SNMP Card Configuration Tool Setting
1. Install the SNMP Card Configuration Tool from the included CD
2. Run the “wsnmpcfg” program in the “All Programs”->“SNMP Card Configuration Tool”.
3. The main dialog of the “SNMP Card Configuration Tool” program is shown as Figure. 1. The
configuration tool will display all the SNMP cards present on the network. The "Refresh"
button is used to search the entire local network for SNMP cards.
Figure 1. The main window of the “SNMP Card Configuration Tool” program.
4. Choose “Setup as selected” under the ”Tool” menu or double click the SNMP card device.
5. You can modify the new IP, new subnet mask, and new gateway address through the IP or
MAC address in the SNMP card setting window, as shown in figure 2.